Dd Wrt Bridge Mode Wired Full WAP Or

One can link a wireless network to a wired network allowing you to bridge two networks with different infrastructure.

You can find wireless access points products that offer either a bridge mode or a repeater mode.

In this post, Im going to explain three popular open source choices that can use for setting up a wireless bridge.

This device has two IP address and it is located in downstairs.

Dd Wrt Bridge Mode Wired Full WAP Or

You can either setup a full WAP or just bridge your LAN so that wireless devices can get access to all LAN resources transparently.

It works great with variety of wireless routers and embedded systems.

This is recommend for new users as it comes with easy to use web-gui.

It features a new easy to use GUI, a new bandwidth usage monitor, more advanced QOS and access restrictions, enables new wireless features such as WDS and wireless client modes, raises the limits on maximum connections for P2P, allows you to run your custom scripts or telnetssh in and do all sorts of things like re-program the SESAOSS button, adds wireless site survey to see your wifi neighbors, and more.

Instead of trying to create a single, static firmware, OpenWrt provides a fully writable filesystem with package management.

This frees you from the application selection and configuration provided by the vendor and allows you to customize the device through the use of packages to suit any application.

This option requires good understanding of Unix, networks and embedded devices.

This option is only recommended for advanced hardcore unix users.

Open a browser and type: Make sure LAN setup is as follows: Fig.03: Netgear N600 (DGND3700) Static Lan IP Configuration For Wireless Bridge.

Unless you are implementing subnetting, use 255.255.255.0 as the subnet mask (computed by the router).

I set it to 300Mbps performance mode, with a maximum Wireless-N speed.

Make sure LAN is setup as follows: Fig.05: Totmato USB firmware LAN setup for wireless bridge.

You are done. Configure any other settings you wish at this point.

To see current router status click on Status Overview: Fig.09: Tomato status page running in a bridge mode.

I use a stock Linksys E2500 as the main Router because of the simultaneous dual band capability.

I have a Linksys E2000 running Tomato Toastmans build on 5ghz band for my home theater so that I can provide wired ethernet to a Roku and a Blue Ray player.

I also have a Linksys WRT160N v1 also running Tomato Toastmans build to provide wired ethernet to my home office.

This allows for watching video on 5ghz without any interference to the data network running on 2.4ghz.

Figure 03 looks good, but right under it Step 1, I believe should be 192.168.1.2 and Step 2, you have 25 instead of 255 for the first part of the subnet mask.

Wireless Network Mode has to be set to Auto when its in wireless client mode I see in your last figure that its set that way.